The Vyper Go is a cutting-edge fitness device that uses pressure and high-intensity vibration to amplify the traditional foam rolling experience. It accelerates warmup and recovery, releases tension and tightness in the muscles, and helps to maintain full range of motion while promoting overall wellbeing and performance.
OPERATING
To turn on, press down on the power button for three seconds until LED lights illuminate. Press again once for speed level one, twice for speed level two and speed three times for level three. The blue LED lights will indicate the corresponding speed level. Do not use directly on a hard surface. Use only on a carpeted floor or a fitness mat. To turn off, press down on the power button for three seconds. The device is fully turned off when all the LED lights are off. The device will turn off after 10 minutes of use. To continue use, turn device on again and set to desired level.
CHARGING
Fully charge for two hours before first use. To charge, connect the adapter to the charging port and plug into wall outlet. LED lights will illuminate to show battery level and indicate active charging. LED lights will remain illuminated when fully charged while adapter is plugged in. Device may be recharged at any time and at any battery level. It is not recommended to fully deplete the battery to the red LED level. Fully recharge the device monthly to best prolong battery life. The average run-time per charge is two hours at level three, and longer at lower levels. It is recommended to turn the device OFF while the it is not in use or during storage and travel.
CLEANING AND STORAGE
Make sure the power is OFF and the battery charger is not attached. Use a damp, clean, cloth and gently wipe your Vyper Go. Store in a clean, cool, dry place, out of direct sunlight, when not in use. Any other servicing should be performed by an authorized service representative.
CONNECTING TO THE HYPERICE APP
To connect your device to the Hyperice App via Bluetooth® make sure that your device is turned on, Bluetooth® is turned on in your phone, and your device is within close proximity. Select a routine within the Hyperice App and if prompted tap “Scan for Devices.” Select your device when it pops up on the screen. HyperSmart™ will automatically start your device and adjust the speed and intensity as you follow along with the routine
Additional Product Information & Specifications