Operating
Turn your Vyper 3 ON by pressing the power/speed setting button and holding it down for 3 seconds and release. Now press the power button once again to start speed level one, twice to turn device to speed level two and three times for speed level three. Press the power button again and the device will remain on with no vibration, and on standby. The single BLUE LED blinking light indicates the device is on and on standby mode. The 3 WHITE LED lights will indicate the corresponding speed levels. The GREEN LED lights indicate the corresponding battery level. The Vyper 3 device is pre-programmed to turn off after 10 minutes of use, please note this a normal pre-set device setting. To continue use, simply press the power button again and select the desired level. To turn OFF your device, press and hold power/speed setting button down for 3 seconds until all LEDs are off.
Charging
Fully charge battery for up to four hours before first use. To charge, connect the DC end
of the supplied charger to the charging port on the Vyper 3 and plug the charger into a wall outlet. The Green LEDs will light up sequentially to show battery level and indicate active charging. Full charge is indicated when the LEDs remains solid. Battery may be recharged at any time and at any battery level. It is not recommended to fully deplete the battery. The average runtime is 2+ hours depending on the speed level used. Your device will not operate while plugged into the charger.
Cleaning and storage
Make sure the power is OFF and the battery charger is not attached. Use a damp, clean, cloth and gently wipe your product if needed. Store in a clean, cool, dry place, out of direct sunlight, when not in use.
Additional Product Information & Specifications