Operating
Turn your Hypervolt Go 2 ON by pressing the power/speed setting button for three seconds. Once your device is powered ON the battery level indicator (LED band) at the base of the handle will illuminate. Press the power/speed setting button again to select speed one. Your Hypervolt Go 2 is now ready for use. Change speeds (1-3) by pressing the power/speed setting button once per speed. The lights will indicate the current speed.
Changing attachment heads
Only change attachments after the speed setting is set to off and the head attachment stops moving. To change head attachments, pull the existing head attachment straight out to remove and insert the desired head directly into the opening while pushing firmly.
Charging
Fully charge the battery for up to four hours before first use. To charge, connect the DC end
of the supplied charger to the charging port on the bottom of the handle and plug the charger into a wall outlet. The LED light band will pulsate to show the battery level and indicate active charging. The LED light band colors correspond to the charge level ranging from red (low) to green (fully charged). Full charge is indicated when the LED band remains green and fully illuminated. The battery may be recharged at any time and at any battery level. It is not recommended to fully deplete the battery to the red LED level. The average runtime is 2+ hours depending on speed level and pressure applied during use. Your device will not operate while plugged into the charger.
Cleaning and storage
Make sure the power is OFF and the battery charger is not attached. Use a damp, clean, cloth and gently wipe your Hypervolt Go 2. Store in a clean, cool, dry place, out of direct sunlight, when not in use.
Additional Product Information & Specifications