Operating
Turn your Hypervolt Go 3 ON by pressing and holding the power setting button for 0.5 seconds. Once your device is powered ON the battery level indicator (LED band) at the base of the handle will illuminate. Turn the encoder dial to change speeds (1-5). The lights will indicate the current speed. To power off, simply hold the power button down for 0.5 seconds.
Changing head attachments
Only change attachments after speed setting is turned to off and head attachment stopped moving. To change head attachments, pull the existing head attachment straight out to remove and insert the desired head directly into the opening while pushing firmly.
Charging
Fully charge battery for up to four hours before first use. To charge, connect the USB-C cord into the charging port on the bottom of the handle and plug the cord into a USB-A adapter. Then plug the adapter into the wall. The LED light band will pulsate to show battery level and indicate active charging. The LED light band colors correspond to the charge level ranging from red (low) to green (fully charged). Full charge is indicated when the LED band remains green and fully illuminated. Battery may be recharged at any time and at any battery level. It is not recommended to fully deplete the battery to the red LED level. The average runtime is 2+ hours depending on speed level and pressure applied during use. It is recommended to turn the device OFF while the device is not in use or during storage and travel.
Cleaning and storage
Make sure the power is OFF and the battery charger is not attached. Use a damp, clean cloth and gently wipe your Hypervolt Go 3. Store in a clean, cool place, out of direct sunlight, when not in use.